Installation Guide

AdvanTech
™
Subfloor Adhesive // Installation Guide
3
AdvanTech
™
Subfloor Adhesive Safe Use and Handling
- Important – Read all directions and cautions before use. Refer to product Safety Data Sheet (SDS) prior to
handling or using AdvanTech
™
subfloor adhesive.
- Always wear proper personal protective equipment including gloves, clothing and eye protection. Wash
hands thoroughly after handling.
- Do not store in hot vehicle, direct sunlight or temperatures exceeding 122º F (50º C).
- Do not breathe in mist, vapors or spray. Use in areas with adequate ventilation.
- Use drop cloths to protect areas below from accidental contact.
- Product is flammable during dispensing. Keep away from open flame, sparks, heat or other sources of
ignition. Do not smoke while using this product.
- Can is pressurized. Do not pierce or burn even after use.
- Do not ingest.
- Read full product label and SDS for precautionary instructions before use.
- Do not use in any application inconsistent with manufacturer’s intended use or recommendations.
- KEEP OUT OF REACH OF CHILDREN
- CAUTION: Contains MDI monomer, polyurethane resin, and propane/isobutene. Cured foam exposed to
temperatures greater than 240º F (116º C) may release hazardous decomposition products.
AdvanTech
™
Subfloor Adhesive First Aid
- EYE CONTACT: Immediately remove contact lenses if possible. With eye open, flush thoroughly with
running water for at least 15 minutes and immediately seek medical attention.
- SKIN CONTACT: Immediately wash affected areas with large amounts of running water and soap and rinse
thoroughly. Do not pull solidified product off of skin. Any residue or cured foam will gradually wear off.
Alternatively, foam can be removed by applying generous amounts of petroleum jelly or lanolin and wait one
hour. Using plastic gloves, firmly wipe off affected area with a clean cloth. Repeat if necessary. Do not use
solvents to remove wet or cured foam. If irritation develops, seek medical attention.
- INHALATION: Overexposure to vapors may cause dizziness or headache. Move to fresh air. If having trouble
breathing, seek medical attention.
- INGESTION: Rinse out mouth and drink plenty of water. DO NOT induce vomiting. Immediately seek
medical attention.
Storage, Handling and Disposal
- SHELF LIFE: Product will keep for 18 months in unopened can when stored between 60º F and 90º F (16º C
and 32º C) in a dry and well-ventilated area. Storage above 90º F (32º C) will reduce shelf life.
- STORAGE AND HANDLING: Do not store cans above 122º F (50º C) and avoid freezing. Ideal storage temperature is
60º F-90º F (16º C-32º C). If can is left in freezing conditions, place in room temperature conditions 10 minutes prior
to use. Do not expose cans to conditions that may damage, puncture or burst the cans. Once started, do not remove
applicator gun until can is empty. Completely close control knob and store partially used adhesive can in upright
position with applicator gun attached. Maximum storage for partially used cans is 30 days. If longer storage is required,
remove the applicator gun from the adhesive can and clean as directed. It is NOT recommended to store partially used
adhesive cans without the applicator gun attached.
- DISPOSAL: Dispose of leftover material/containers in accordance with federal, state and local regulations.
See Safety Data Sheet (SDS) for more information.