Installation Guide

- ATTACHMENT TO GUN:
Ensure control knob is in the closed
position (all the way right/clockwise.) Place
threaded end of container into applicator gun
basket and rotate in a clockwise direction
until tight. Do not over-tighten.
- PREPARING ADHESIVE: Shake can vigorously
for minimum 30 seconds.
- CONTAINER CHANGEOVER: Once started, do not remove applicator gun from can until can is empty.
Point applicator gun in a safe direction and purge the applicator barrel. Remove can by rotating can in
a counter- clockwise direction. Clean applicator
basket with AdvanTech
™
polyurethane cleaner as needed.
- Immediately attach new can of AdvanTech
™
subfloor adhesive.
AdvanTech
™
Subfloor Adhesive // Installation Guide
4
Adhesive Can Attachment and Changeover
- APPLICATOR GUN:
Control Knob
Handle
Trigger
Basket
Tip
AdvanTech
™
Subfloor Adhesive Installation / Application
Always refer to local building codes prior to application of AdvanTech
™
subfloor adhesive. Read all product directions
and safety information before use. You are fully and solely responsible for all safety requirements. Good construction
practices should be followed at all times.
Step 1 // Safety
Adhesive foam bonds quickly to skin – wear gloves, eye protection and work clothes during application.
Never point the nozzle at yourself or others and always assume applicator gun is pressurized.
Step 2 // Surface Preparation
Surface should be free from oil, grease and standing water. Adhesive may be applied in temperatures from 20º F (-6º C)
to 105º F (41º C). Use drop cloths as necessary. Product will gun slowly when cold.
Step 3 // Adhesive Preparation
Place threaded end of can into applicator gun basket and rotate in a clockwise direction until tight. Do not over-tighten.
Shake container vigorously for minimum 30 seconds prior to initial application.
Barrel