Installation Guide

AdvanTech
™
Subfloor Adhesive Cleanup
AdvanTech
™
polyurethane foam cleaner cleans wet foam from hands, tools and applicator guns. It can attach directly
to the applicator gun and spray right from the can to clean the inside of the gun.
With partially used cans of adhesive, keep the gun attached and close the control knob. Wipe gun tip with rag at the
end of each use or spray tip with AdvanTech polyurethane foam cleaner to prolong applicator gun life. Any cured
adhesive on applicator tip can be removed by safely scraping with a utility knife or other sharp object. Cured adhesive
on guns that are PTFE coated can be removed by hand. In between can changeovers, it is recommended to spray the
basket of the gun using the AdvanTech polyurethane foam cleaner.
To clean an applicator gun that will be stored by itself with no adhesive can attached, remove empty adhesive can
from gun basket by rotating in a counter-clockwise direction. Spray applicator basket using AdvanTech polyurethane
foam cleaner, then attach cleaner can directly to the gun by placing threaded end into applicator gun basket and ro-
tating clockwise until tight. While pointing applicator gun in a safe direction, depress trigger until only cleaner comes
out of the tip of the gun.
Close control valve and remove cleaner can. Rotate control knob in a clockwise direction until closed for storage.
SUBFLOOR ADHESIVE
AdvanTech
™
Subfloor Adhesive // Installation Guide
6
Troubleshooting
Adhesive will not spray straight out of the gun: Check the gun tip and remove any dried adhesive. If the problem persists,
remove the subfloor adhesive and clean the applicator gun with AdvanTech polyurethane foam cleaner. If the problem still
continues, the inside of the gun applicator may be clogged, and it is recommended to obtain a new applicator gun.
Adhesive sprays inconsistently: Shake the can vigorously for at least 30 seconds to improve the spray pressure. If the problem
persists, remove the subfloor adhesive and clean the applicator gun with AdvanTech polyurethane foam cleaner. If the problem
still continues, the inside of the gun applicator may be clogged, and it is recommended to obtain a new applicator gun.
Questions? Call or visit our website
p 800.933.9220
w AdvanTechSFA.com