Operation Manual

Problem Possible cause Solution
The door has been opened too
frequently.
Do not keep the door open longer
than necessary.
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
The room temperature is too
high.
Decrease the room temperature.
The FROSTMATIC function is
switched on.
Refer to "FROSTMATIC function".
The temperature in the
freezer is too low.
The temperature regulator is not
set correctly.
Set a higher temperature.
The FROSTMATIC function is
switched on.
Refer to "FROSTMATIC function".
The temperature in the
freezer is too high.
The temperature regulator is not
set correctly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
Many products are stored at the
same time.
Store less products at the same
time.
Products are too near to each
other.
Store products so that there is
cold air circulation.
A large quantity of drops
ice covers the top com-
partment inside the ap-
pliance.
There is too much frost and ice
on the evaporator of the appli-
ance, the door was open for too
long time.
Refer to "Cleaning the evapora-
tor".
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
Cleaning the evaporator
1. Switch off the appliance.
2. Disconnect the mains plug from the mains socket.
3. Remove all foods from the freezer and put them in a fresh place.
4. Move the appliance far from the wall.
5. Leave the door open.
6. After approximately 20 minutes the drain hose at the rear of the cabinet starts to
discharge water into the drip tray.
What to do if…
25