Operating instructions

H E A T I N G
W A T E R H E A T I N G
Your water is heated by the heat exchanger unit. There is a communal hot water cylinder located
in the basement. Water from the rising main is directly heated and distributed from the basement
to the hot taps around your apartment. There is a control on the heat exchanger to set the
temperature of the hot water from the taps. This has been ‘factory set’ at 40
o
and shouldn’t need
to be adjusted.
A programmer is provided to turn the heating on and off and you should adjust the settings to
suit your own requirements. In cold weather it might be necessary to leave the heating on for
longer periods than in milder weather. A room thermostat is provided to regulate room
temperatures room by room. Usage of the hot water (via the heat exchanger) will be billed by the
managing agents who are able to monitor your hot water usage from a central reader and bill you
accordingly.
M A I N T E N A N C E
Heat Exchanger - The Heat Exchangers should be checked and serviced at least once a year by an
Evinox engineer so that they remain safe.
The managing agent will arrange for an approved Gas Safe Registered engineer to service your Heat
Exchanger annually. Access will be required to the Heat Exchanger and the managing agent will
contact you in good time to arrange this. The cost of servicing the heat plate exchangers and the
communal boiler will be included in your utility invoice.
Under floor heating – there is no special maintenance required for the under floor heating system. It
is guaranteed for 10 years (but not for accidental damage).
Failure to return any warranty documents could invalidate your warranty.