User manual

English
33
General Operation
Switch device on/off
With the STANDBY button (6), you can switch the unit be-
tween standby and operating mode.
NOTE: In CD mode
After about 10 minutes without signal, or if the signal is too
weak, the device will automatically switch to standby.
Volume
By pressing the VOL+/VOL- buttons (11) you can adjust the
desired volume.
FUNCTION (7)
Press the FUNCTION button until the desired operating
mode is shown on the display.
Radio mode
1. Fully uncoil the wire antenna.
2. Searching radio stations:
Brieypressthe / buttons (3/14), until you have found
the radio station which you are looking for. If you keep
one of the buttons pressed down, the device will search
totheprevious,respectivelynextradiostation.
Preset station:
1. Search for the desired radio station with the
/
buttons (11).
2. To store the radio stations, press the PROG/TIME SET
button (13). The notification “P 01” will blink in the
display.
3. Select the desired preset location with the M+/M-
buttons (12).
4. Press the PROG/TIME SET button to store the sta-
tion.
3. If the reception is too weak and there is interference on
the received station, try to improve the reception by
altering the position and uncoiling or coiling the antenna.
The message “ ” is shown on the display for stereo
reception.
Select the preset radio station
The preset radio stations can be selected by repeatedly
pressing the M+/M- button (12).
Playing CDs/MP3
1. Select the CD mode with the FUNCTION button (7). The
following will appear in the display “- -”.
2. OpentheCDcompartment(2)usingthetab(1)toipthe
cover of the CD compartment open to the front.
3. Place a CD with the label on top onto the spindle so that
the CD clicks in mechanically.
4. Close the CD compartment.
5. The CD will play from the first title.
6. In order to remove a CD, press the button (4), open the
CD compartment and lift the CD out carefully.
Always keep the CD deck closed.
NOTE:
• Ifadiscisinsertedthewrongwayaround,respectivelyif
no disc is inserted, then the message “- -” will blink and
“ ” appears on the display.
• PlaybackofCDsproducedbytheusercannotbe
guaranteed due to the large variety of software and CD
media available.
Description of the control buttons
(5)
Youcanbrieyinterruptandresumeplaybackusingthis
button. The fade-in in the display will blink. Pressing again
continues playback.
/ (3/14)
With
youcanjumptothenextorprevioustracketc.
• Ifthebuttoniskeptpresseddown,themachinestartsto
search through the tracks. (The sound is muted.)
The button can be used as follows:
Pressonce= Thisstartsthecurrenttrackagainfrom
the beginning.
Presstwice= Thisjumpsbacktotheprevioustrack.
Pressthreetimes= Thisplaysthesongbeforeetc.Ifthe
button is kept pressed down, the
machine starts to search through the
tracks. (The sound is muted.)
(4)
The playback is stopped.
PROG/TIME SET (13)
During the playback of an audio CD:
Pressonce= thecurrenttrackisrepeatedcontinu-
ously. The notification “
” will appear
in the display.
Presstwice= thewholeCDisplayedcontinuously.
The notification “
ALL” will appear in
the display.
Pressthreetimes= Thenotication“RAND” will appear
in the display. All the titles will be
played back successively in a random
sequence.
Pressfourtimes= allfunctionsarecancelled.Thenormal
play mode is resumed.