User manual

1
2
B
2. Pull the door trim to the front to
remove it.
3. Hold the door glass panels on their
top edge one by one and pull them
upwards from the guide.
4. Clean the door glass panels.
To install panels, do the same steps in
reverse.
11.7 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The back lamp
The lamp glass cover is at
the back of the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
4. Install the glass cover.
11.8 Removing the drawer
WARNING!
When the oven is in use,
heat can build up in the
drawer. Do not keep
flammable things in there
(e.g. cleaning materials,
plastic bags, oven gloves,
paper, cleaning sprays, etc.).
The drawer below the oven can be
removed for cleaning.
1. Pull the drawer out until it stops.
1
2
2. Lift the drawer at a small angle and
remove it from the drawer support
rails.
Inserting the drawer:
1. To insert the drawer set the drawer
on the support rails. Make sure that
the catches engage correctly into the
rails
2. Lower the drawer until it is horizontal
and push it in.
12.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
www.aeg.com34