Owner's manual

Problem Possible solution
You cannot activate the appli-
ance.
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse
in the fuse box.
The programme does not start. Make sure that the appliance door is closed.
Press the start button.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
The appliance does not fill with
water.
Make sure that the water tap is open.
Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is
not clogged.
Make sure that the inlet hose has no kinks or
bends.
The appliance does not drain
the water.
Make sure that the sink spigot is not clog-
ged.
Make sure that the drain hose has no kinks
or bends.
The anti-flood device is on. Close the water tap and contact the Service.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
If other alarm codes appear, contact the
Service.
9.1 The washing results and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not
clean.
The filters are clogged. Clean the filters.
The filters are not correctly
assembled and installed.
Make sure that the filters
are correctly assembled and
installed.
The spray arms are clog-
ged.
Remove remaining soil with
a thin pointed object.
The programme was not
applicable for the type of
load and soil.
Make sure that the pro-
gramme is applicable for
the type of load and soil.
30
www.aeg.com