FAVORIT 78735 VI1P EN User Manual
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 6 4. CONTROL PANEL...........................................................................................................6 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com 1.2 Children and vulnerable people safety • • • • • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Do not let children play with the appliance. Keep all detergents away from children.
ENGLISH 5 • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. 2.5 Internal light WARNING! Risk of injury. WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. 2.4 Use • Do not sit or stand on the open door. • Dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 12 11 10 1 2 3 4 5 6 7 8 9 10 11 12 9 8 7 6 5 4 3.1 Beam-on-Floor Top spray arm Upper spray arm Lower spray arm Filters Rating plate Salt container Air vent Rinse aid dispenser Detergent dispenser Lower basket Upper basket Cutlery drawer The Beam-on-Floor is a light that shows on the kitchen floor below the appliance door. • When the programme starts, a red light comes on and stays on for all the duration of the programme.
ENGLISH 3 4 5 6 Delay button Program button ExtraHygiene button TimeSaver button 7 Multitab button 8 ProBoost button 9 Indicators 4.1 Indicators Indicator Description End indicator. Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. 5.
www.aeg.com Programme Degree of soil Type of load Programme phases Options P7 5) • Fresh soil • Crockery and cutlery • Wash 60 °C • Rinses • ExtraHygiene • Multitab • Normal soil • Crockery and cutlery • • • • • Multitab 6) P8 Prewash Wash 50 °C Rinses Dry 1) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil. (This is the standard programme for test institutes).
ENGLISH Programme 1) Water (l) Energy (kWh) Duration (min) P8 9 - 10 1.0 - 1.2 219 - 229 9 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. 5.2 Information for test institutes info.test@dishwasher-production.com For all the necessary information for test performance, send an email to: Write down the product number (PNC) that is on the rating plate. 6. SETTINGS 6.
www.aeg.com German degrees (°dH) French degrees (°fH) mmol/l Clarke degrees Water softener level 37 - 42 65 - 75 6.5 - 7.5 46 - 52 8 29 - 36 51 - 64 5.1 - 6.4 36 - 45 7 23 - 28 40 - 50 4.0 - 5.0 28 - 35 6 19 - 22 33 - 39 3.3 - 3.9 23 - 27 5 1) 15 - 18 26 - 32 2.6 - 3.2 18 - 22 4 11 - 14 19 - 25 1.9 - 2.5 13 - 17 3 4 - 10 7 - 18 0.7 - 1.8 5 - 12 2 <4 <7 <0.7 <5 1 2) 1) Factory setting. 2) Do not use salt at this level.
ENGLISH 6.4 Use of rinse aid and multitablets When you activate the option Multitab, the rinse aid dispenser continues to release rinse aid. However you can deactivate the rinse aid dispenser. In this case the drying results may not be satisfactory. With the rinse aid dispenser deactivated, the rinse aid indicator is always off. How to deactivate the rinse aid dispenser The appliance must be in programme selection mode. 1.
www.aeg.com and detergent functions. They can also contain other cleaning or rinsing agents. The display shows the updated programme duration. This option deactivates the release of salt. The salt indicator does not come on. 7.3 ExtraHygiene With the use of this option the programme duration is prolonged to increase the cleaning and drying results with the use of multi-tablets. With this option you have better hygiene results.
ENGLISH The salt is used to recharge the resin in the water softener and to assure good washing results in the daily use. How to fill the salt container 13 8.2 How to fill the rinse aid dispenser A B 1. Turn the cap of the salt container counterclockwise and remove it. 2. Put 1 litre of water in the salt container (Only for the first time). 3. Fill the salt container with dishwasher salt. C 4. Remove the salt around the opening of the salt container. 5.
www.aeg.com 9.1 Using the detergent A B C CAUTION! Only use detergent specifically designed for dishwashers. 1. Press the release button (A) to open the lid (C). 2. Put the detergent, in powder or tablets, in the compartment (B). 3. If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. 4. Close the lid. Make sure that the lid locks into position. 9.
ENGLISH 15 Cancelling the programme End of programme Press and hold simultaneously When the programme is completed and you open the door, the appliance is automatically deactivated. and until the appliance is in programme selection mode. Make sure that there is detergent in the detergent dispenser before you start a new programme. Close the water tap. 10. HINTS AND TIPS 10.
www.aeg.com • Do not put in the appliance items made of wood, horn, aluminium, pewter and copper. • Do not put in the appliance items that can absorb water (sponges, household cloths). • Remove remaining food from the items. • Make soft the remaining burned food on the items. • Put hollow items (cups, glasses and pans) with the opening down. • Make sure that cutlery and dishes do not bond together. Mix spoons with other cutlery. • Make sure that glasses do not touch other glasses.
ENGLISH 17 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 11.2 Cleaning the spray arms Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object. 11.
www.aeg.com • If you regularly use short duration programmes, these can leave deposits of grease and limescale inside the appliance. To prevent this, we recommend to run long duration programmes at least 2 times per month. 12. TROUBLESHOOTING If the appliance does not start or it stops during operation. Before you contact an Authorised Service Centre, check if you can solve the problem by yourself with the help of the information in the table. With some problems, the display shows an alarm code.
ENGLISH 19 12.1 The washing and drying results are not satisfactory Problem Possible solution There are whitish streaks or bluish layers on glasses and dishes. • The release quantity of rinse aid is too much. Adjust the rinse aid selector to a lower position. • The quantity of detergent is too much. There are stains and dry water drops on glasses and dishes. • The released quantity of rinse aid is not sufficient. Adjust the rinse aid selector to a higher position.
117898070-B-102014 www.aeg.