User manual

7. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer
to ’Setting and starting a pro-
gramme’.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
• If you use the combi detergent
tablets, activate the Multitab op-
tion.
5. Set and start the correct programme
for the type of load and the degree
of soil.
7.1 Using the detergent
20
30
M
A
X
1
2
3
4
+
-
A
B
C
1.
Press the release button (B) to open
the lid (C).
2.
Put the detergent in the compart-
ment (A) .
3.
If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4.
If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
7.2 Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the
appliance. The appliance is in setting
mode when all the programme indica-
tors come on and the display shows 2
horizontal status bars. If the control pan-
el does not show this condition, press
and hold, at the same time Delay and
Start until the appliance is in setting
mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Close the appliance door.
4. Press Program again and again until
the indicator of the programme you
want to set comes on. You can also
set the applicable options.
• The duration of the programme
flashes in the display.
• The indicators of the phases that
are foreseen for the programme
come on.
5. Press Start to start the programme.
• When the programme starts, only
the indicator of the running phase
stays on.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
• The Delay indicator comes on.
ENGLISH 11