User manual

the indicators , , and
start to flash and the display is blank.
2. Press .
• The indicators , and go
off.
• The indicator
continues to
flash.
• The display shows the current
setting: e.g. = level 5.
3. Press
again and again to change
the setting.
4. Press the on/off button to confirm
the setting.
6.3 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If you are using multi-
tabs containing rinse aid and you are
satisfied with the drying result, you can
deactivate the notification for refilling
rinse aid. However, we recommend that
you always use rinse aid for best drying
performance.
If you use standard detergent or multi-
tablets without rinse aid, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously and until
the indicators
, , and
start to flash and the display is blank.
2. Press .
• The indicators
, and go
off.
• The indicator continues to
flash.
• The display shows the current
setting.
– = rinse aid empty
notification activated.
– = rinse aid empty
notification deactivated.
3. Press to change the setting.
4. Press the on/off button to confirm
the setting.
6.4 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously and until
the indicators
, , and
start to flash and the display is blank.
2. Press .
• The indicators
, and go
off.
• The indicator continues to
flash.
• The display shows the current
setting:
–
= Acoustic signal off.
–
= Acoustic signal on.
3. Press to change the setting.
4. Press the on/off button to confirm
the setting.
6.5 AirDry
AirDry improves the drying results with
less energy consumption.
www.aeg.com
52