User manual

Problem Possible cause Remedy
comes on.
There is no cookware on the
zone.
Put cookware on the zone.
The cookware is incorrect. Use the correct cookware.
Refer to “Hints and tips”
chapter.
The diameter of the bottom
of the cookware is too small
for the zone.
Use cookware with correct
dimensions.
Refer to “Technical informa-
tion” chapter.
FlexiBridge function oper-
ates. One or more sections
of the function mode which
operates are not covered by
the cookware.
Place the cookware on the
correct number of sections
of the function mode which
operates or change the func-
tion mode.
Refer to "Flexible induction
cooking area" chapter.
PowerSlide function oper-
ates. Two pots are placed on
the flexible induction cook-
ing area.
Use only one pot.
Refer to "Flexible induction
cooking area" chapter.
and a number come on.
There is an error in the hob. Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.
comes on.
There is an error in the hob
because a cookware boiled
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.
Deactivate the hob. Remove
the hot cookware. After ap-
proximately 30 seconds, acti-
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware
become sufficiently cool.
Check if your cookware is
compatible with the hob.
Refer to “Hints and tips”
chapter.
ENGLISH 23