User manual

• Insert the filter in the slot found in the
back of the air lever flap.
• Close the air lever flap.
The filter should be handled
carefully so fragments do not
loosen from the surface.
Make sure that the air lever flap
is closed to obtain proper func-
tion.
8.4 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
8.5 Rear spacers
2
4
3
1
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1.
Release the screw.
2.
Engage the spacer below the screw.
3.
Turn the spacer to the right position.
4.
Tighten again the screws.
8.6 Levelling
Accurate levelling prevents the vibration
and noise of the appliance during opera-
tion. To adjust the height of the appli-
ance loosen or tighten the two adjusta-
ble front feet.
34
www.aeg.com