Operation Manual

15
UK
Note:
If there are no numbers in the redial list, the display shows “EMPTY ”.
7.9.2 Store a redial number into the phonebook
tFollow Steps 1 and 2 in section 7.9.1.
tPress
O
K
and / to select “ADD TO PB“.
tPress
O
K
and then enter the name you want to use in the phonebook.
tPress
O
K
and then modify the number, if necessary.
tPress
O
K
to show “MELODY 1“.
tPress
/ to browse the ringtone list. The respective ringtone will be
played when browsing the ringtone list.
Note
The selected melody will only be played when you receive a call if you
subscribe to Caller Display and the incoming number matches the stored
number.
tPress
O
K
to confirm, and the entry will be stored.
7.9.3 Delete a redial number
tFollow Steps 1 and 2 in section 7.9.1.
tPress
O
K
and / to select “DELETE“.
tPress
O
K
to confirm, and the entry will be deleted.
7.9.4 Delete all redial list entries
tFollow Steps 1 and 2 in section 7.9.1.
tPress
O
K
and / to select “DELETE ALL“.
tPress
O
K
to display “CONFIRM?“.
tPress
O
K
to confirm. All entries will be deleted and the display will show
“EMPTY“.
7.10 Find the handset
You can locate the handset by pressing the find key
14
. All the handsets
registered to the base will produce the paging tone and show “PAGING“
on the display for 60 seconds.
You can stop the paging by pressing
on any handset or on the
base again.
Note:
If there is an incoming call during paging, the phone will ring with the
incoming call instead of paging.