Operation Manual
29
UK
tPress and / to select “CHANGE PIN“.
tPress
to show “PIN?----“, then enter the Old PIN. (Default Remote Access PIN is 0000).
tPress
to show “NEW PIN?----“, then enter your new 4-digit PIN.
tPress
to show “CONFIRM?----“, then enter your new 4-digit PIN again.
Note:
If the new PIN entered in Step 6 is not the same as the new PIN entered in Step 5, you must enter the new
system PIN at step 5 again.
tPress
to reconfirm.
12.5.9.2 Activate or Deactivate the Remote Access
tPress
and / to select “ANS. MACHINE“.
tPress
and / to select “TAM SETTINGS“.
tPress
and / to select “REMOTE ACC“.
tPress
and / to select “ON“ or “OFF“ to turn the remote access on or off respectively.
tPress
to confirm.
12.5.9.3 Access Your Answering Machine Remotely
You can ring your phone from another tone-dialling phone to switch the answering machine on or off, and/
or listen to your messages remotely.
tPlace a call from a tone-dialling phone to your phone.
tWhen the answering machine answers the call and starts playing the OGM, press the * key. The OGM
will stop playing
tEnter the 4-digit Remote Access PIN (default PIN is 0000). You will hear a single beep if the 4 digits are
accepted, and then will need to press 5 to start playing any messages.
Note:
The * may be entered during or after the OGM, and the 4-digit PIN should be follow without any delays.
Note:
If the 4-digit Remote Access PIN is not accepted, you will hear a multiple beep, and if it is entered
incorrectly three times consecutively, the line will be released automatically.
tPress the following keys to carry out your desired function.
Keys Functions
While message is not playing While message is playing
2 Delete the current message playing
4 Repeat playing the current message from the
beginning. Press twice to skip backward to
play the previous message
5 Play the message Stop the current message playback
6 Skip to play the next message
7 Turn on the answering machine
8 Stop the current message palyback
9 Turn off the answering machine
Note:
If your answering machine is switched off, the phone will enter into the remote access mode after 14 rings.
You can then enter the <*> key and the 4-digit remote access PIN (Default Remote Access PIN is 0000) to
activate the remote access feature.
Using the corded base
12.6 Switching the TAM On/Off
When the TAM is switched on, the TAM ON/OFF indicator will be turned on, and it will flash if there are
new messages recorded.