Installation Guide

19
3. Once the handrail assembly is located squarely, lock the handrail in position by winding in the grub
screws on the underside of each handrail bracket.
4. Once the handrails are locked in position, fit the handrail endcaps. The endcaps should be carefully
pushed into place until they sit flush with the outside face of each bracket (a light smear of lubricant such
as, hand or dish soap on the end cap ‘O’ rings may ease fitment.
5. Finally, fit the plinth facia to the magnets on the front of the plinth. Make sure that the plinth facia is
centrally located and does not overhang the range.
Commission the AGA Dual Control, as stated in the relevant Installation Instructions and carry out functional
test on each of the features of the AGA Dual Control.