Installation Guide

4
GENERAL NOTES
NOTE: THESE INSTALLATION INSTRUCTIONS SHOULD BE LEFT WITH THE RANGE AND THE USER TO
RETAIN FOR FUTURE REFERENCE.
DELIVERY REQUIREMENTS
The AGA DC3 arrives on 1 pallet.
Vent Pipe Installation kit (AG1M212542) arrives in a separate carton.
There must be access to the kitchen to manipulate a foot print of 39
9
/16 (1005mm) x 29
1
/8” (740mm). A
wooden template (skate with castor wheels) of dimensions 39
9
/16” (1005mm) x 29
1
/8” (740mm) could be
used to check if the AGA Dual Control fully built appliance is able to fit through the property grounds and
doors into its installation position in the kitchen. It must also be considered that the height of the appliance is
37
3
/4” (960mm) off pallet and 43
1
/4 ” (1100mm) on the pallet, so high level obstacles/restrictions must not be
overlooked.
GENERAL INSTALLATION REQUIREMENTS
The installation of the range must be in accordance with the relevant requirements of the local Wiring and
Building Regulations. It should be in accordance also with any relevant requirements of the local or state codes.
In your own interest and that of safety to comply with the law, all appliances should be installed by an authorized
AGA distributor in accordance with the relevant regulations.
CAUTION:
THIS UNIT IS HEAVY, PROPER EQUIPMENT AND ADEQUATE
MANPOWER MUST BE USED IN MOVING THE RANGE TO
AVOID DAMAGE TO THE UNIT OR THE FLOOR