Product Manual

98
EN
Set-up for manual slopes
The Agatec RL110/RL110G can be used to manually create slopes for
special applications, stairways, sloped ceilings, etc.
For slopes up to 10%, set up the laser in horizontal mode and use the
keypad or remote to set the slope following the instructions below.
In full manual mode, the unit will not self-level on both axis, meanwhile
the head will continue to rotate. The plane of laser light can be tilted in
either one or both planes.
To use the laser in full manual mode:
• After turning the laser on and allowing it to self-level, press the Manual
button {B-7}. The LED {B-10} indicates that the laser is in manual mode
and you can set slope in the X-axis.
• Press UP/DOWN keys to adjust the slope of the X-axis.
Press the Manual key {B-7} once more to set slope on Y-axis. The LED
{B-10} blinks to indicate that the laser is in manual mode and you can
set slope in the Y-axis.
Keep pressed the MAN key to exit the manual mode and return to the
automatic mode.
• Thirty seconds later, the LED will blink slowly, indicating the H.I. Alert
function is activated.
• If the laser is disturbed while in H.I. Alert mode, the head will stop
rotating, the beam will turn off, the LED indicator will be on continuously.
• Press the ON/Off key to turn off the H.I. Alert function. Press again the
ON/OFF key to have the unit going back to the default settings (300 rpm,
automatic mode).
Rotation mode
The head rotates at three speeds: 0, 300, 450, 600 rpm. The default setting
is 300 rpm. The laser beam is more visible at slower rotation speeds.
• To cycle through the rotation speeds press the key {B-5}. Press once
to get to 450 rpm, twice to 600 rpm (max speed), three times to get to
point mode. One more time to get back to 300 rpm.
• When in point mode, the point can be moved to the right or left using
the UP/DOWN keys {B-3 and B-4}. It is also possible to move the head
manually to position the beam point.
To start rotation again, press the key {B-5}.
Scanning mode
For interior applications, scanning mode allows you to see the beam
easier at a distance.
The default width has medium dimension. The laser beam is more visible
at small width.
• To scan press the key {B-6}.
• To cycle through the scan width, press the key {B-6}. Press once to
increase the width, twice to increase more. One more time to get to the
mimium width.
• The scanning beam can be moved to the right or left using the
UP/DOWN keys {B-3 and B-4}.
Wall Mount
For interior application, such as drywall installation, it is recommended to
use the wall mount (optional).
Use the tripod thread to fix the mount to the laser.
Accessories
Remote Control
The Remote Control has five buttons.
1) LEFT
2) RIGHT
3) Scan / Rotation Mode
4) UP
5) DOWN
Please refer to the table in "Button Functions" to better understand their
functionality.
• The red LED at the top of the remote will flash each time a button is
pressed, indicating that the remote is transmitting to the laser.
• Battery - To open the battery compartment and change the battery,
push the battery cover in the direction of the arrow. The remote control
requires alkaline battery.