Product Manual

1110
EN
Other accessories
• Laser enhancing glasses improve the visibility of the laser beam in
bright light conditions.
• The ceiling grid targets are used to view the beam on suspended ceiling
applications. The target attaches magnetically to the grid.
Low battery Indicator
When the battery power is low, the LED {B-9} will blink red during
operation. Batteries have to be replaced as soon as possible. When
battery is empty, the laser head will stop rotating and the low battery
LED {B-9} will stay on.
Replacing alkaline batteries
Follow the steps below to replace the alkaline batteries in your laser.
• To access the battery compartment, loosen the knobs connecting the
laser to the wall mount.
• Use a coin or small screwdriver to remove the cover of the battery
compartment at the back of the laser.
• Insert two fresh alkaline batteries (D size or LR20), following the
polarization indicated at the bottom of the battery compartment. The plus
contact is rounded and raised. When replacing batteries, change both at
the same time.
• Replace the compartment and tighten with a coin or screwdriver.
Batteries
Receiver/Remote Control
(depending on scope of delivery)
The receiver/remote control is a combination of receiver and laser
remote control. With power turned OFF, the unit performs as a remote.
The receiver/remote control has six buttons; two of which have dual
functions depending on whether the unit is being used as a receiver or
as a remote.
1) Audio (Receiver), LEFT Scan-Stationary Beam / Manual Slope
(Remote)
2) Bandwidth (Receiver), RIGHT Scan-Stationary Beam / Manual Slope
(Remote)
3) Power – On/Off (Receiver)
4) Scan / Rotation Mode
5) UP – Head Speed / Scan Width
6) DOWN – Head Speed / Scan Width
• The receiver/remote control can be used as a receiver and
attached magnetically to the ceiling grid to be used in place of the ceiling
grid target in poor visibility conditions.
Receiver
(depending on scope of delivery)
The receiver has all receiver functions of remote receiver, without the
remote control functions.
1) Audio
2) Bandwidth
3) Power ON/OFF
(Keys 4, 5 and 6 are only available on remote receiver)
Check and Adjust
Notes and Responsibilities
• It is the responsibility of the user to follow operating instructions and
to periodically check the accuracy of the instrument and work as it
progresses.
• The laser is adjusted to the defined accuracy specifications at the