User`s guide
Table Of Contents
- Overview
- Getting Started
- System Setting
- Making Measurements
- Measuring Multiple Signals
- Measuring a Low-Level Signal
- Improving Frequency Resolution and Accuracy
- Making Distortion Measurements
- One-button Power Measurement
- Making a Stimulus Response Transmission Measurement
- Measuring Stop Band Attenuation of a Low-pass Filter
- Making a Reflection Calibration Measurement
- Measuring Return Loss Using the Reflection Calibration Routine
- Making an Average Power Measurement
- Key Reference
- SCPI Command Reference
- Error Messages
- Menu Map
6 SCPI Command Reference
120 N9340A User’s Guide
Control Limit line Buzzer
:CALCulate:LLINe[1]:BUZZer[:STATe]
OFF|ON|0|1
:CALCulate:LLINe[1]:BUZZer[:STATe]?
This command toggles the audio warning between
on and off. If data exceeds the limit line the buzzer
will sound an alarm.
Control Limit Line Testing
:CALCulate:LLINe[1]:[STATe] OFF|ON|0|1
:CALCulate:LLINe[1]:[STATe]?
This command toggles the limit line testing
between on and off.
If the limit line is turned on, the limit pattern is
automatically turned off.
Set Limit Line Y-axis value
:CALCulate:LLINe[1]:Y <ampl>
:CALCulate:LLINe[1]:Y?
This command sets the Y- axis value of a limit line.
Limit line Y-axis value is set independently and is
not affected by the X- axis units.
*RST state: Off
Key access: [Limit] > {Beep}
*RST state: Off
Key access: [Limit] > {Limit Line}
*RST value: 0 dBm
Available unit: dBm, -dBm, mV, uV
Key access: [Limit] > {Limit Line}