user manual

104 Chapter 7
COM Object Reference
SCPI.SENSe(Ch).MULTiport.PORT(Pt).SELect
SCPI.SENSe(Ch).MULTiport.PORT(Pt).SELect
Object type Property
Syntax SCPI.SENSe(Ch).MULTiport.PORT(Pt).SELect = Va lu e
Va lu e = SCPI.SENSe(Ch).MULTiport.PORT(Pt).SELect
Description For channel 1 to channel 4, specifies ports to which the reflection port (port 1) of the
test set and the transmission port (port 2) are connected. The same port cannot be
specified as a port to which port 1 and port 2 are connected.
Variable
For information on the variable (Ch), see Table 7-2, “Variable (Ch),” on page 91.
Examples
Dim Port_num As Integer
SCPI.SENSe(1).MULTiport.PORT(1).SELect = 1
Port_num = SCPI.SENSe(1).MULTiport.PORT(1).SELect
Related objects SCPI.SENSe(Ch).MULTiport.STATe on page 107
SCPI.SENSe(Ch).CORRection.MULTiport.COLLect. ACQuire.LOAD on
page 93
Table 7-3 Variable (Pt)
Pt
Description Port number
Data type Long integer type (Long)
Range 1 to 2
Preset value 1
Note If the specified variable is out of the allowable setup range, an error occurs when executed.
Val ue
Description Port number to which the specified port is connected.
Data type integer type (integer)
Range 1 to 12
Preset value Reflection port: 1 Transmission port: 2