user manual

140 Chapter 9
Service
Parts List
The defective assembly must be returned for credit under the terms of the
rebuilt-exchange assembly program.
Shipping the Defective Assembly Back to Agilent
1. When the rebuilt assembly is received, be careful not to damage the box in
which it was shipped. You will use that box to return the defective assembly.
The box you receive will contain the following:
• The rebuilt assembly
• An exchange assembly failure report
• A return address label
2. Complete the failure report.
3. Place the failure report and the defective assembly in the box. Be sure to remove
the enclosed return address label.
4. Seal the box with tape.
If you are inside the United States, stick the preprinted return address label over
the label that is already on the box and return box to Agilent. (Agilent pays
postage on boxes mailed within the United States.)
If you are outside the United States, do not use the return address label; instead,
contact Agilent Technologies for instructions.
(Refer to page 120.)