user manual

10 Chapter 1
Introduction and Installation
Installation
Table 1-1 Test Set Accessories Supplied
Item No. Description Quantity Part Number
1 Power Cord 1 See Figure 4-3.
2 Type-N Cable (Analyzer to test set’s
REFLECTION Port)
1
1. Not to be used with a rack-mounted system or if the analyzer has had its bottom feet removed.
See Figure 1-6 to see how these cables are to be connected.
1(75 Ω) 87075-60026
3 Type-N Cable (Analyzer to test set’s
TRANSMISSION Port)
1
1(75 Ω) 87075-60028
4 Type-N Cable (Analyzer to test set’s
REFLECTION Port)
2
2. You will only receive these cables if you ordered Option 1CM (rack mount kit). Use these cables
if you are rack-mounting your system, or if the bottom feet of the analyzer have been removed.
See Figure 1-6 for information on how to connect these cables.
1(75 Ω) 87075-60027
5 Type-N Cable (Analyzer to test set’s
TRANSMISSION Port)
2
1(75 Ω) 87075-60029
6 Parallel Port Interface Cable 1 8120-6818
7 87075C User's and Service Guide (for E506x
Network Analyzers)
87050E and 87075C User’s and Service Guide
(for 871x Network Analyzers)
1
1
87075-90027
87050-90026
8 Test Set Calibration Disk 1 N/A
9 Performance Test Programs Disks
(DOS and LIF formats)
1 08714-60049
10 CD-ROM 1 08714-90051