user manual

12 Chapter 1
Introduction and Installation
Installation
Step 3. Connect the Test Set to the Analyzer
For using your system on a bench, configure and connect the two instruments as
shown in Figure 1-3: Connect the Parallel In connector of the test set to the analyzer
Parallel connector. Use the parallel cable that was shipped with the multiport test
set.
If you will be installing your system in a rack, read “Installing the System in a
Rack,” next in this section, before connecting the test set to the analyzer.
Figure 1-3 System Configuration
Installing the System in a Rack
The rack mount kit for the test set is Option 1CM when ordered with the test set, or
part number 5063-9214 when ordered separately.