user manual

Chapter 2 27
Making Measurements
Measurement Procedures
Performing Measurements
The procedure to execute measurement is described below. This section describes
how to trigger actual measurement. For more information, see the E5061A/62A
User’s Guide.
Step 1. Setting the trigger source
Select a trigger source. Because the trigger source is common to all the channels,
you need not to set it channel by channel.
[Trigger] -
Trigger Source - Corresponding softkey
Step 2. Setting the trigger mode
Select a trigger mode. You must set it separately for each channel.
[Trigger] - Corresponding softkey
Step 3. Generating a trigger
Generate a trigger from the trigger source specified in setting the trigger source.
NOTE If the internal trigger is specified, triggers are generated continuously immediately
after the setting.
Step 4. Adjusting the settings
Adjust each setting made in “Setting the measurement conditions” according to your
measurement needs.