Use and Care Manual

5
FIGURE 2
FIGURE 3
B
N
8
O
H
M
L
STEP 2: (SEE FIGURE 2)
• Hook the short end of the spring (M) into the hole in
the foot pedal latch. Use the spring puller tool (L) to
hook the long end of the spring into the square hole
in the tongue. The spring puller tool can be stored
when nished.
STEP 3: (SEE FIGURE 3)
• Assemble the end of the hitch bracket (8) down
through the slot at the front of the tongue. Fasten it
to the tongue using the hex bolt (B) and hex nut (H).
Tighten.
• Assemble the hitch pin (N) and hair cotter pin (O) to
the tongue and hitch bracket.
FIGURE 4
9
2
STEP 4: (SEE FIGURE 4)
• Lay the tongue (open side facing up) onto the wheel
support (2). Assemble the axle (9) through the wheel
support and the tongue.
STEP 5: (SEE FIGURE 5)
• Assemble a washer (J), a wheel (6) with the valve
stem facing out, and another washer (J) onto the axle.
Assemble a cotter pin (K) to the axle. Repeat for other
wheel.
FIGURE 5
6
J
J
K