Use and Care Manual

6
FIGURE 7
FIGURE 6
C
I
E
4
3
D
F
STEP 6: (SEE FIGURE 6)
• Assemble the latch stand plate (3) and the latch
stand bracket (4) at the front of the tray using four hex
bolts (C), washers (I) and hex nuts (E). The aligning
tab on the bottom of the latch stand bracket must be
towards the rear of the cart. Tighten.
STEP 7: (SEE FIGURE 7)
• Place the tray onto the wheel support and position
it so that the latch stand bracket locks into the foot
pedal latch. Fasten the tray to the wheel support
using eight hex bolts (D) and hex nuts (F). Tighten.
HINT: Using tape to hold the hex bolts in place may ease
assembly.