Use and Care Manual

11
• Assemble the latch stand plate (17) and latch stand
bracket (13) WITH ALIGNMENT TAB TOWARD
REAR OF CART to the cart tray using four 1/4" x 3/4"
hex bolts (D) and 1/4" nylock nuts (I). Tighten nuts
after all bolts are in place. DO NOT OVERTIGHTEN.
See gure 4.
J
20
F
FIGURE 5
I
TAB
D
17
13
FIGURE 4
• Place the cart bed braces (20) and the cart tray
onto the wheel support. Secure latch stand bracket
underneath the tongue's latch lock lever. See gure 5.
• Assemble the cart tray and cart bed braces to the
wheel support using eight 5/16" x 3/4" hex bolts (F)
and 5/16" nylock nuts (J). Tighten nuts after all bolts
are in place. DO NOT OVERTIGHTEN. See gure 5.
21
O
9
M
(IF SPACE
ALLOWS)
M
A
FIGURE 3
• Assemble an axle clip (O), a wheel (9) and a 5/8"
washer (M) onto each end of the axle. Assemble a
second 5/8" washer onto each end of the axle if space
allows. Secure both wheels in place using two cotter
pins (A) and bending the ends. See gure 3.
FIGURE 6
• Attach the engine mounting plate to the tongues
using two 3/8" x 3" hex bolts (B) in the back holes,
two 3/8" x 1" hex bolts (C) in the front holes and
four 3/8" nylock nuts (K). See gure 6. Note: Engine
shown may be different from your unit.
HINT: For easier assembly, support the rear tongue with
a block of wood.
C
B
K
K