Use and Care Manual

12
16
8
11
HOSE ADAPTER
(NOZZLE)
FIGURE 7
FIGURE 8
FIGURE 9
• Place the hose hanger rod (16) down into the hose
hanger bracket on the impeller housing assembly.
See gure 8.
• Place a hose clamp (8) onto the end of the hose
(11). Push the hose onto the hose adapter (nozzle).
Tighten the hose clamp onto the hose and hose
adapter. Do not collapse the hose adapter when
tightening the clamp. See gure 9.
• The remaining hose clamp will be used later to fasten
the hose to the deck adapter.
• Attach the transition snout (18) to the top of the
engine housing using four 5/16" x 3/4" hex bolts (E)
and nylon washers (L). Attach the short hose (7) to
the transition snout using a hose clamp (8) See gure
7. Note: Engine not shown for clarity.
HINT: Push in on hex bolts as you tighten to form threads.
15
16
FIGURE 10
• Loop the 25" tarp strap (15) under the hose. Fasten
the hooks to the hose hanger rod (16). See gure 10.
E
L
18
8
7