Use and Care Manual

FIGURE 11

• Insert the hose through the hole in the cover and

secure with the drawstring lock. See gure 14.

FIGURE 14

FIGURE 12

• Insert support tubes (22) into both upper and lower

holes in the side rails. Make sure the support tubes

are positioned as shown below. See Figure 12.

• Slide the cover (2) over the side rails. Make sure the

hole for the hose is facing the front of the cart.

FIGURE 13

CART COVER ASSEMBLY

• Insert four 1/4" x 1" bolts (P) upwards through the

holes in the side of the cart bed. Slide on a washer

(Q) and spacer (H) onto each bolt. Attach a side

rail (14) with the opening towards the inside of the

cart, small hole towards the front and larger hole

towards the back and secure with a 1/4" nylock nut (I).

Repeat for the other side. See gure 11.