Use and Care Manual

TOOLS REQUIRED FOR ASSEMBLY

(1) Adjustable Wrench

(2) 7/16" Wrenches

(2) 1/2" Wrenches

(2) 9/16" Wrenches

Lay out and identify the parts and hardware using the

illustrations on page 3 and page 4.

ASSEMBLE THE HITCH MOUNT ASSEMBLY

STEP 1: (SEE FIGURE 1)

• Insert a slider tube (7) into each end of the hitch

mount assembly (8).

• Attach the slider tube to the hitch mount assembly

using two hex bolts (C), four washers (L), and two

Nylock hex nuts (H). Do not tighten.

FIGURE 1

STEP 2: (SEE FIGURE 2)

• Attach the hitch mount assembly (8) to the tractor

frame using two U-bolts (6) secured with two mounting

brackets (5), four washers (J), and four Nylock hex

nuts(E). Do not tighten.

• If the slider tube does not fully extend into both

U-bolts(6), then loosen the appropriate hex bolt (C)

and reposition the slider tube (7).

• Center the hitch mount assembly on the tractor frame.

• Tighten all hex bolts and hex nuts.

FIGURE 2

ASSEMBLY INSTRUCTIONS