Use and Care Manual

USING THE SPRAY GUN

1. Shut off the boom by turning the boom valve to

"OFF".

SPRAYER RECIRCULATION

1. The sprayer is equipped with a recirculation valve to

aid in material agitation and pressure control.

2. This valve is in the “open” position when the valve

handle is in line with the hose (pictured), “closed”

when perpendicular to the hose.

3. Adjusting the recirculation valve between the open/

closed positions will affect the pressure coming

through the spray wand only.

4. Closed position is full pressure through spray wand or

boom.

5. It may be helpful to adjust the pressure when

spraying with the spray wand to avoid damage to

plants from excess pressure.

6. This valve should be in the “closed” position when

operating the boom.

MAINTENANCE

AFTER EACH USE

1. Fill the sprayer part way with water and pump the

water out through the boom assembly and the

handgun. Use the handgun to wash the inside of the

tank.

2. Rell the tank about half full with water and a

chemical neutralizer solution and repeat the cleaning

instructions above. Follow the manufacturers

instructions for disposal of all chemicals.

AS NEEDED

1. Periodically clean the tank strainer on the end of the

intake hose. Remove the nylon swivel nut from the

hose, pull out the screen and ush it with water.

2. Periodically clean the strainers in the boom nozzles.

Remove the nozzle, pull out the screen and ush it

with water.

WINTER STORAGE

1. Drain all water out of the sprayer, especially the pump

and handgun. These items are prone to damage from

freezing temperatures.

2. Winterize the sprayer by pumping a 50-50 solution

of water and R.V. antifreeze through the boom

assembly and the hand gun.