English Thank you for purchasing the AG 700 amplifier! The AG 700 has the clarity, dynamic range and fast transient response of the legendary AG 500 with a bigger low-end and high headroom. This solid state amplifier provides 700 continuous watts at either 4 or 2.67 ohms, boasts an incredibly flexible EQ section, and also features a series effects loop, XLR balanced output and two rear panel speakon outputs. All in a 4.9 lb. (2.22 kg) package! Table of Contents I. Important Safety Instructions page 2 II.
I. Important Safety Instructions WARNING: To reduce the risk of fire or electric shock, do not expose equipment to rain or moisture. Aguilar Amplification assumes no responsibility for any damage or injury that results from improper use or service. CAUTION: RISK OF ELECTRIC SHOCK! DO NOT OPEN! There are no user serviceable parts inside of this product. This is a high voltage device, and internal voltages can be lethal. Any and all work should be performed by qualified personnel only. 1. 2. 3. 4. 5. 6. 7.
II. Getting Started A. Manual Conventions: In this manual, words that appear in italics represent actual physical controls on the AG 700. B. Basic Setup: Input Voltage: 100-240~VAC 50/60 Hz Mains Fuse: Internal T 6.3 A H/250 V Maximum power consumption: 835 W The AG 700 features a universal AC mains input, allowing it to operate on any standard AC mains voltage ranging from 100 to 240 volts with frequency of either 50 or 60 Hz.
1. Turn the Gain up while playing. 2. If you have a particularly high output instrument, it may be necessary to push the –10 dB button in to prevent clipping of the input circuit. This button is located above the Input jack 3. Turn up the Master control until you reach desired volume. C. Protection Features The AG 700 is equipped with several protection circuits designed to prevent any damage to the amplifier in cases where the limits of the normal operating range are breached.
D.I. Section: D.I. Nominal Output Level: -20 dBu D.I. Pre/Post Button: Pre - Your signal goes to the D.I. XLR output jack before your Gain and EQ settings, but after the –10 dB input pad. Post – Gain, EQ, and effects will be sent to the D.I. XLR output jack. In this setting adjustments to the Master control will only affect the output to your speaker cabinets, not the signal going to the D.I. Lift/Ground: If there is a hum when using the D.I. there may be a ground loop.
IV. Warranty Information The AG 700 is covered under limited warranty against defects in materials and workmanship for a period of 3 years. This warranty is non-transferable. The warranty period starts from the date of purchase from an authorized Aguilar dealer. Please retain your sales receipt, as it is necessary to obtain warranty service. Before sending your unit to Aguilar for repair, you must receive a return authorization number from us. Please contact us via email (techsupport@aguilaramp.com).
Español Gracias por adquirir el amplificador AG 700! El AG 700 tiene la claridad, el rango dinámica y la respuesta transitoria rápida del legendario AG 500 con mayor low-end y un alto headroom. Este amplificador de estado sólido proporciona 700 vatios continuos a 4 ó 2,67 ohmios, cuenta con una sección de EQ increíblemente flexible y también cuenta con un loop de efectos en serie, salida balanceada XLR y dos salidas speakon en panel trasero. ¡Todo en un paquete de 4.9 libras (2.22 kilogramos)! Contenido I.
I. Instrucciones de seguridad importantes ADVERTENCIA: Para reducir el riesgo de incendio o de descarga eléctrica, no deje expuesto este equipo a la lluvia o a la humedad. Aguilar Amplification no asume ninguna responsabilidad por cualquier daño o lesión que resulte de un uso o mantenimiento inapropiado. PRECAUCIÓN: ¡RIESGO DE DESCARGA ELÉCTRICA! ¡NO ABRIR! No hay piezas dentro del producto que puedan ser reparadas por el usuario.
II. Primeros pasos A. Convenciones del manual En este manual, las palabras que aparecen en cursiva representan los controles físicos reales en el AG 700. B. Configuración básica Voltaje de entrada: 100-240~VCA 50/60 Hz Fusible: Interno T 6,3 A H/250 V Máximo consumo de energía: 835 W El AG 700 cuenta con una entrada de corriente CA universal, que le permite funcionar con cualquier voltaje estándar de CA de 100 a 240 voltios con frecuencia de 50 o 60 Hz.
1. Gire Gain mientras toca. 2. Si tiene un instrumento de salida particularmente alta, puede ser necesario pulsar el botón -10 dB para evitar la saturación del circuito de entrada. Este botón está situado por encima del conector de entrada (Input). 3. Suba el control Master hasta llegar al volumen que necesita. C.
Sección de D.I.: D.I. Nivel de salida nominal: -20 dBu D.I. botón de Pre/Post: Pre – La señal va al conector de salida D.I. XLR antes de la configuración de Gain y EQ, pero después de la entrada -10 dB. Post – Gain, la configuración de EQ y los efectos serán enviados al conector de salida D.I. XLR. Lift/Ground: Si hay zumbidos cuando se utiliza el D.I. puede haber un bucle de tierra. En muchos casos, este problema se puede solucionar pulsando el botón de Lift/Ground.
IV. Información sobre la garantía Servicio de garantía fuera de los EE.UU.: El Servicio de garantía puede ser diferente en su país. Por favor, póngase en contacto con el distribuidor de Aguilar en su país para conocer los términos y procedimientos. Para encontrar distribuidor Aguilar de su país, por favor vaya a http:// www.aguilaramp.com/shop_international_dealers.htm. V.
Deutsch Danke, dass Du den AG 700 gekauft hast! Der AG 700 hat die Klarheit, den Dynamikumfang und die schnelle Ansprache des legendären AG 500 mit einem tieferen Low-End und massig Headroom. Dieser Transistor Verstärker liefert konstante 700 Watt an 4 oder 2,67 Ohm, hat eine sehr flexible Klangreglung und einen seriellen Einschleifweg. Darüberhinaus verfügt der AG 700 über einen Balanced Out XLR-Anschluss und zwei Speakon Boxenanschlüsse. Das alles bei einem Gewicht von nur 2,22 kg. Inhaltsverzeichnis I.
I. Wichtige Sicherheitshinweise ACHTUNG: Zum Verringern des Risikos eines Brands oder eines Stromschlags darf das Gerät nicht Regen oder Feuchtigkeit ausgesetzt werden. Aguilar Amplification übernimmt keine Haftung für jegliche Schäden oder Verletzungen, die durch unsachgemäße Verwendung oder Wartung verursacht wurden. ACHTUNG: STROMSCHLAGGEFAHR! NICHT ÖFFNEN! Es befinden sich im Innern des Produkts keine Teile, die vom Nutzer gewartet werden müssen.
II. Inbetriebnahme A. Erklärung In dieser Bedienungsanleitung bezeichnen Wörter in kursiver Schrift die tatsächlichen Kontrollregler des AG 700. B. Grundeinstellungen Netzspannung: 100-240~VAC 50/60 Hz Sicherung:intern T 6,3 A H/250 V Maximale Leistungsaufnahme: 835 W Der AG 700 verfügt über ein Schaltnetzteil. Dadurch ist er bei Spannungen von 100 bis zu 240 Volt und Frequenzen von 50 oder 60 Hz einsetzbar.
1. Drehen Sie den Gain Regler während Sie spielen hoch. 2. Wenn Sie ein Instrument mit besonders hohem Ausgangssignal haben, könnte es notwendig sein, den -10 dB Taster zu betätigen, um die Übersteuerung der Eingangstufe zu verhindern. Der Taster befindet sich über der Input Buchse. 3. Drehen Sie den Master Regler bis zur gewünschten Lautstärke. C.
D.I. Sektion: D.I. Ausgangspegel: -20 dBu D.I. Pre/Post Knopf: Pre – Ihr Signal geht zur D.I. XLR Ausgangsbuchse bevor es zur Gain und EQ Einstellung aber nach dem -10 dB input pad zur Senkung des Signalpegels gelangt. Post – Gain, EQ Einstellungen, und Effekte werden an die D.I. XLR Ausgangsbuchse gesendet. Lift/Ground: Wenn bei der Verwendung des D.I. Ausgangs ein Brummen aufkommt, besteht die Möglichkeit, dass eine Masseschleife vorliegt.
IV. Informationen zur Garantie Für Fragen, die die Gewährleistung betreffen, wenden Sie sich bitte an den Händler, bei dem Sie das Produkt erworben haben. V. Umweltschutz Dieses Symbol bedeutet, dass Elektro- und Elektronik-Altgeräte (WEEE) nicht mit dem Hausmüll entsorgt werden dürfen. Bitte wenden Sie sich an Ihre örtliche Behörde oder Ihren Händler, um weitere Informationen über die nächste WEEESammelstelle und die Recyclingberatung zu erhalten. Aguilar Amplification LLC 599 Broadway, 7th fl.
Français Félicitations pour l’achat de l’amplificateur basse AG 700! Le AG 700 offre la clarté, la plage dynamique et la rapidité de réponse du légendaire AG 500 avec une plus grosse présence dans les fréquences basses et un haut niveau de headroom. Ce solide ampli délivre 700 watts continus à 4 ou 2,67 ohms, dispose d’une section EQ ultra flexible ainsi que d’une boucle d’effets en série, des sorties XLR symétriques et deux sorties speakon en façade arrière.
I. Consignes de sécurité importantes MISE EN GARDE : Pour prévenir les risques d'incendie ou d'électrocution, veillez à ne pas exposer l'appareil à la pluie ou à l'humidité. Aguilar Amplification décline toute responsabilité en cas de dommage ou blessure résultant d'un usage ou d’un entretien inappropriés. ATTENTION : RISQUE D’ÉLECTROCUTION ! NE PAS OUVRIR L'APPAREIL ! le produit ne contient aucune pièce qui peut être réparée par l'utilisateur.
II. Débuter A. Conventions du manuel Dans ce manuel, les mots qui apparaissent en italique représentent les contrôles physiques réels du AG 700. B.
1. Augmentez le Gain tout en jouant. 2. Si vous avez un instrument particulièrement puissant, il peut être nécessaire de pousser le bouton -10 dB pour empêcher le clip de s’activer. Ce bouton est localisé à coté du jack Input. 3. Augmentez le réglage de volume Master jusqu’à ce que vous atteigniez le volume désiré. C.
Section D.I.: Niveau de sortie nominal D.I.: -20 dBu Bouton Pre/Post D.I. : Pre - votre signal à la sortie D.I. XLR avant vos réglages de Gain et d’EQ, mais après la protection d’entrée -10 dB. Post - le Gain, les réglages d’EQ, et les effets seront envoyés à la sortie D.I. XLR. Lift/Ground : Si vous constatez un bourdonnement en utilisant le D.I., cela peut-être du à une boucle à la terre. Dans de nombreux cas enfoncer le bouton Lift/Ground peut résoudre ce problème.
IV. Information sur la garantie Service de garantie en dehors des Etats-Unis : Le service de garantie peut être différent dans votre pays. Veuillez entrer en contact avec le distributeur d’Aguilar de votre pays pour obtenir des informations sur les conditions et procédures. Pour trouver le distributeur de votre pays, merci de visiter http://www. aguilaramp.com/shop_international_dealers.htm V.