User Manual

SmartyCam
User Manual
Release 1.22 – firmware version 1.03.10
16
www.smartycam.com
Chapter 5 – SmartyCam configuration
In order to configure SmartyCam data overlay
2
SmartyManager software – exclusively
developed by AIM – needs to be used.
With SmartyManager it is possible to:
• change/add/cancel overlay configurations;
• download from www.smartycam.com “Updates” area a new firmware release and
upgrade with it SmartyCam;
• download SmartyCam movies;
• see SmartyCam movies.
This software is provided with a CD included in SmartyCam kits and can be downloaded
from www.smartycam.com, “Updates” area.
There are two possible SmartyCam configuration mode.
Connecting SmartyCam to the PC:
• set the preferred data overlay;
• transmit the new configuration to SmartyCam;
• SmartyCam will automatically set that configuration.
Not connecting SmartyCam to the PC:
• set the preferred data overlay;
• copy the new configuration on the MicroSD previously inserted in the PC reader;
• insert the Micro SD in SmartyCam;
• enter “Conf. load” option and select “Smarty Conf” (paragraph 6.4.2.1);
PLEASE NOTE: before connecting SmartyCam to the PC it is mandatory installing
SmartyManager software (see SmartyManager user manual at
www.smartycam.com, “Updates” area)
Refer to SmartyManager user manual for data overlay configuration information
SmartyCam slave needs its master (AIM logger or SMC Bridge) configuration through
Race Studio 2 software, included in both the slave kits with 2m and 4m power cable).
PLEASE NOTE: SmartyCam configuration is independent from its master
configuration: it is thereby unnecessary to modify it changing SmartyCam master.
2
Selection of data to visualize, layout and position.