User Manual

MN-957
10
ASSEMBLING THE AIR SPRINGS ASSEMBLIES
1. Set a roll plate (H) over the air spring (G).
The radiused (rounded) edge of the roll plate (H) will be towards the air spring, so that the air
spring is seated inside both roll plates.
2. Install the swivel fitting (I) into the top of the air spring finger-tight plus one-and-a-half
turns (fig. 22). Repeat for both air springs.
3. Set the upper air spring bracket (D) onto the air spring so that the slot is on the fitting
side (it will only bolt on one way) and attach with two 3/8” screws (J), two lock washers
(K) and two flat washers (L) (fig. 23). Torque the mounting hardware to no more than 20
lb.-ft. (27Nm). Repeat for the opposite side. Figure 24 shows the left- and right-hand
assemblies.
LoadLifter 5000
Left-hand
assembly
Right-hand
assembly
g. 23
g. 24
D
J
K
L
I
H
g. 22
NOTE