User Manual

MN-957
14
LoadLifter 5000
Installing the Air Lines
This section explains how to set up the air spring kit to be controlled with Schrader
valves and a separate compressed air source. An on-board air compressor system allows
for hassle-free control of the air springs. Learn more about Air Lift control systems at
www.airliftcompany.com/products/compressor-systems.
1. Choose a convenient
location for mounting
the inflation valves
(fig. 34). Popular
locations for the
inflation valve are:
a. The wheel well
flanges
b. The license
plate recess in
bumper
c. Under the gas
cap access door
d. Through the
license plate
NOTE
Whatever the chosen location, make sure there is enough clearance around the inflation
valves for an air chuck.
2. Drill 5/16” holes to install the inflation valves.
3. Cut the air line assembly in two equal lengths.
4. Place a 5/16” nut and
star washer on the air
valve. Leave enough
of the inflation valve
in front of the nut to
extend through the
hole and have room
for the rubber washer,
flat washer, and 5/16”
nut and cap. There
should be enough
valve exposed after
installation –
approximately 1/2” – to easily apply a pressure gauge or an air chuck (fig. 35).
5. Push the inflation valve through the hole and use the rubber washer, flat washer, and
another 5/16” nut to secure it in place. Tighten the nuts to secure the assembly.
6. Route the air line along the frame to the fitting on the air spring. Keep AT LEAST 6” of
clearance between the air line and the exhaust system. Avoid sharp bends and edges.
Use zip ties to secure the air line to fixed points along the chassis. Be sure that the tie
straps are tight, but do not pinch the air line. Leave at least 2” of slack to allow for any
movement that might pull on the air line.
7. Cut off the air line, leaving approximately 12” of extra air line. A clean square cut will
prevent leaks. Insert the air line into the air fitting. This is a push-to-connect fitting.
Wiggle the hose back and forth while inserting to make sure the hose bottoms out in the
fitting to obtain a good seal.
TECH TIP
Option 1:
Option 2:
g. 34
Air line to
air spring
Star
washer
Vehicle body
or bumper
Hex nut
Hex nut
Rubber
washer
Flat
washer
Valve
Cap
Schrader
valve
g. 35