User Manual

MN-957
6
3. Install the left-hand (driver-side) frame bracket (B) onto the frame, ensuring that the
flange is on the inside of the frame. The large hole under the bracket will be behind
the axle as shown (fig. 5). Attach with the M10 hex cap screw (P) and lock washer
(S), making sure that the bracket is parallel to the ridge that is under the frame rail.
Torque to 35 lb.-ft. (47Nm). Repeat for the right-hand (passenger) side.
4. In order to install the lower brackets, remove the stock M8 hardware holding the
brake/ABS and emergency brake line brackets to the spring perches (figs. 6 and 7)
and pull the brackets slightly away from the spring perch.
The frame
has a ridge;
the bracket
must be
parallel to
this ridge.
The large
hole in
the upper
bracket will
be behind
the axle.
The flange
on the
bracket
must be
inboard of
the frame.
Emergency
brake cable
forward of
passenger
side
LoadLifter 5000
S
P
g. 7
g. 6
g. 5