User Manual

MN-957
7
5. On the front of the driver-side spring perch there is a hole and a slot (fig. 8). In order
to mount the lower bracket it will be necessary to tap the hole using the 5/16” self-
tapping bolt (M) by starting the bolt making sure it is perpendicular to the perch. Use
a ratchet and socket to drive the bolt in, creating the threads in the spring perch (fig.
9). Remove the bolt for later use.
If you have a model, which on the passenger side, does not have an emergency brake cable
bracket and mounting bolt as noted (has an open hole like noted on driver-side) Follow step
5 for this side by self-tapping the hole as specified.
6. Set the lower bracket (F1 or F2) on the axle making sure the tabs wrap around the
spring perch (fig. 10). Repeat for the other side.
LoadLifter 5000
It will be necessary
to tap the round hole
in the forward driver-
side spring perch. If
there is no emergency
brake cable bracket
and mounting bolt
as specified in fig
7 on the passenger
side, repeat and tap
the round hole as
instructed.
Note:
Four-wheel
drive
installation
shown.
M
g. 8
g. 9
g. 10
NOTE