User manual

Step 1
Step 5
Step 2
Step 6
Step 3 Step 4
The ID code has now been copied to each
of the units and they are paired together.
Follow the instructions for Set Zone Codes to
complete setup.
NOTE: The LINK LEDs on all paired units will
light green AFTER you have set the zone codes
and all units are powered ON again.
Setting
OFF
ON
Setting
OFF
ON
Transmitter Transmitter
Transmitter Transmitter
Receiver(s)
Receiver(s)
Receiver(s)
Receiver(s) Receiver(s)
For all receivers: Push the third
dip switch to ON position to
enter pairing mode.
For all receivers: Push the
third dip switch to OFF
position to exit pairing mode.
Press the PWR button on
transmitter to power ON.
With the remote pointing at the transmitter, press the
PAIRING button. Watch the LINK LEDs.
The• transmitter LINK LED ashes for three
seconds and then turns OFF.
The• receiver(s) LINK LED light for one second and
then turn OFF.
Connect the power for all units.
DC IN
9V
Setting
OFF
ON
DC IN
9V
Setting
OFF
ON
L
I
N
K
P
o
w
e
r
M
u
te
S
o
u
r
c
e
P
a
ir
in
g
V
o
l
-
V
o
l
+
Press PAIRING
L
I
N
K
P
W
R
IMPORTANT: Before you begin, follow the sequence of six steps to PAIR each of the receivers
with the transmitter in your installation. You may pair one transmitter with up to two receivers.
You will need the remote control and a small screwdriver for these steps.
!
IMPORTANT: Complete steps 3 and 4
within 10 seconds. Watch the LINK LEDs
to make sure the pairing is successful.
!
For transmitter:
All dip switches
must be in OFF
position.
Receivers are in
pairing mode. PWR
LED lights orange.
Setting
OFF
ON
Transmitter
For transmitter:
All dip switches
must be in OFF
position.
Setting
OFF
ON
Press PWR twice
L
I
N
K
P
W
R
lights green
PWR LED
L
I
N
K
P
W
R
PWR
LED
lights orange
.
Step A Pair Units