Specifications

1
SPECIFICATIONS
Prior to starting, read, understand and observe all
safety precautions & warnings on page 4, 5, 6 & 7 and
all labels and tags on the machine.
WARNING
1. New Sprayer
Your new unit was factory tested in oil, which
was left in the pump. Before using oil-base paint ,
flush with mineral spririts only.
Before using water-base paint , flush with
mineral spirits, followed by soapy water, then a clean
water flush.
2. Changing Colors
Flush with a compatible solvent such as min-
eral spirits or water.
3. Changing From Water-base to Oil-base
Flush with soapy water, then mineral spirits.
4. Changing From Oil-base to Water-base
Flush with mineral spirits, followed by soapy
water, then a clean water flush.
5. Storage
Read prior to using your sprayer
Always relieve pressure (See pressure relief
procedure on page 6) prior to storage or when
machine is unattended.
Oil-base Paint: Flush with mineral spirits. Ensure that
there is no pressure in the unit, then close the prime/
pressure relief valve.
Water-base Paint: Flush with water, then mineral
spirits. For longer term storage use a 50/50 mixture of
mineral spirits and motor oil. Always ensure that there
is no pressure in the unit, and close the prime/pres-
sure relief valve for storage.
WARNING: NEVER LEAVE PUMP UNATTENDED
WHILE UNDER PRESSURE !
6. Start Up After Storage
Before using water-base paint, flush with
soapy water and then a clean water flush.
When using oil-base paint, flush out the
mineral spirits with the material to be sprayed.
INTRODUCTION
FLUSHING -
This airless paint sprayer is a time tested, slow stroking pump - contractor
approved to meet the demanding needs of the professional painting contractor.
AIRLESSCO ALLPRO GPM PRESSURE MAX. TIP SIZE
8 SERIES SL810 810E .81 3000 .021 (1 gun)- .017 (2 guns)
10/11 SERIES SL1100 1000E 1.1 3000 .033(1 gun)- .021 (2 guns)