- Airlink+ Network Router User Manual

Host RJ-11 IP Gateway User Guide, version 9
Installation
FIGURE 5. Wireless Ace: Status
B. Note the IP address listed in the Va l ue column for the command *NETIP.
For *NETSTATE, “Network Ready” means your modem is connected on the cellular network and
waiting for connections. “Network Dormant” means the modem is connected and waiting for con
-
nections but the connection has been idle. In either state, the modem is ready for the steps in the
next section.
Configuring the Intial IP Address for the Host RJ-11 IP
Gateway without a Raven-E
The configuration interface for the Host RJ-11 IP Gateway is web-based, to be able to access the
interface you will need to connect the Host RJ-11 IP Gateway to a computer using Ethernet.
The Port Utility should automatically detect the Host RJ-11 IP Gateway. It may take a short while
for the device to be displayed.
6.
Disconnect your modem’s Ethernet cable from your computer, but leave the modem connected to
power so it remains on the cellular network.
If you are using a Raven-E with the Host RJ-11 IP Gateway, you do not need to use
this utility, skip this section.
If you are able to use the default IP address of the Host RJ-11 IP Gateway, you,
also, do not need to use this utility.
1.
Connect your Host RJ-11 IP Gateway directly to the Ethernet port on your computer and to
power.
2.
Start the Port Utility.
Start > All Programs > Systech Port Server Utilities