- Airlink+ Network Router User Manual

Host RJ-11 IP Gateway User Guide, version 12

Installation

Configuring the IP Address and Interface Port of the Host RJ-

11 IP Gateway

Host RJ-11 IP Gateway Defaults

• Phone port: 8 data bits, no parity, and 1 stop bit (8N1).

• Protocol: American/Bell 212A.

• Maximum baud: 2400.

• DHCP client: disabled.

• IP Address: 192.168.1.3.

Configuring the Host RJ-11 IP Gateway

FIGURE 10. Web Browser : Enter the Location

The web-based interface will open. On the left side of the window are menu options. The central

area of the window is the working area (shown in the close up screen shots for the configuration

settings).

Note: When you have completed configuring the Host RJ-11 IP Gateway, you will

want to reconfigure the IP address on your computer to how it was configured

before you started these steps. Use the directions in this step to reset the configura

tion.

Note: If you are using the defaults for the Host RJ-11 IP Gateway, you can skip this

section and connect your Host RJ-11 IP Gateway directly to your device and net

work.

Connect the Host RJ-11 IP Gateway to power and connect the Ethernet cable from your computer

to the Host RJ-11 IP Gateway.

Type “http://192.168.1.3:9080” (see the example in the screenshot below) in the Address or

Location bar and press the enter key.

Since many cellular carriers block the standard web browser ports (80 and 8080),

the Host RJ-11 IP Gateway uses 9080 by default as the port for the web-based

interface.

http://166.213.236.221:9080

http:192.168.1.3:9080