- Airlink+ Network Router User Manual

Host RJ-11 IP Gateway User Guide, version 16
CHAPTER 3 Hardware
Designed for simplicity, the Host RJ-11 IP Gateway hardware has few complicated parts.
Connectors and Reset button
The Reset button is recessed. To reset the connection, using an unbent paperclip or other narrow,
blunt tip, press and quickly release the reset button. To reset the configuration to the factory default,
press and hold the reset button until you see the appropriate alternating light sequence.
FIGURE 1. Right side: RJ-45 connector, Power connector, and Reset button (not to scale)
FIGURE 2. Left side: RJ-11(phone) connector (not to scale)
Status LEDs
The top panel of the Host RJ-11 IP Gateway displays the status LEDs.
Caution: The Host RJ-11 IP Gateway's RJ-11 phone port should never be con-
nected into the Public Switched Telephone Network (PSTN). This device is
designed to emulate the PSTN for other devices. The Host RJ-11 IP Gateway may
sustain damage not covered by warranty if it is connected to the Public Switched
Telephone Network.
Power
RJ-45 Ethernet
Reset
RJ-11