- Airlink+ Network Router User Manual

Host RJ-11 IP Gateway User Guide, version 24
Configuration Settings and Commands
Once you have created and saved an entry in the table, a link to the associated entry on the Protocol
Settings page appears on the right. If the protocol is not yet defined, this link, “Define protocol”,
will create a new entry on the Protocol Settings page, otherwise the link will be “Edit protocol”.
The translation table screen allows you to add up to 5 new entries at a time. A total of 64 entries
may be configured including the default entry.
In the example above, if the attached device dials 18005551212, the port will be connected to the
host at 192.168.13.100 on TCP port 5004. This host is not yet defined, so it will use the default
TCP protocol. If the attached device dials any other number, the port will be connected to
default.eairlink.com:5003, whose protocol is defined. And the terminal has actually dialed 555-
1212, generating an automatic, but not yet saved, entry.
Network Translation
The Host RJ-11 IP Gateway is capable of accepting incoming TCP connections and redirecting
them to remote TCP hosts. This functionality is called network translation and behaves much like a
TCP “pipe” between two systems. The Host RJ-11 IP Gateway also uses Network Translation to
allow connections to the web-base interface on a port other than the http protocol defined port of
80 which is frequently blocked by cellular carriers.
FIGURE 7. Host RJ-11 IP Gateway: Network Translation
It is also possible to modify the network protocol traveling through the TCP pipe by using the Pro-
tocol Settings page to define the remote host's protocol requirements. The most common use for
this functionality is to add SSL encryption to an incoming TCP connection prior to sending it along
to the remote host.
The Network Translation table is used to define network mappings for TCP pipes. You must first
specify the incoming TCP port to which your device or application will connect. Then, you must
specify the outgoing hostname and destination TCP port for the TCP pipe.
You can also specify the source TCP port for the outgoing TCP connection. Usually, this should be
set to 0 to allow automatic selection of the source port. However, if you have a firewall that