- Airlink+ Network Router User Manual

Host RJ-11 IP Gateway User Guide, version 41
AT Commands
Sn=mm
Sn?
Set register to specified value (page 42)
Return current value formatted as 3
digit decimal
OK(0)
Varies
Vn Result Code Format
0=Numerical result codes
1=Verbose result codes (default)
0
OK
Xn Result Code Format
0=“CONNECT” upon entering online
data state
1-4=“CONNECT <text>” upon enter-
ing online data state
OK(0)
Zn Load factory default settings OK(0)
&Cn DCD Control
0=DCD always on
1=DCD follows connection status
OK(0)
&Dn DTR Control
0=ignore
1=loss of DTR switches to command
mode and leaves connection open
2=loss of DTR switches to command
mode and closes connection (default)
OK(0)
&F
&Fn
Load factory default settings OK(0)
Equivalent to ATZ without dropping the con-
nection. This command does not affect the flash
configuration for the port.
&V
&V0
Display S-register values Example:
E0 Q1 V0 &C1 &D2
S00:002 S02:043 S03:013 S04:010 S05:008
&V1 Status Returns reason for the last disconnect:
TERMINATION REASON......DTR LOSS
TERMINATION REASON….CARRIER LOSS
&W
&W1
Write current configuration to flash OK(0)
&Xnnn Change baud rate.
nnn Baud
3 300
12 1,200
24 2,400
48 4,800
96 9,600
14 14,400
OK(0)
&X Any other & command is ignored OK(0)
Command Function Response