- Airlink+ Network Router User Manual

Host RJ-11 IP Gateway User Guide, version 8
Installation
Private Mode
Configure the Raven-E for Private Mode. In this mode, the modem communicates with the Host
RJ-11 IP Gateway via a static local IP address.
a. Set the *HOSTPRIVMODE to 1.
b. Set the *HOSTPRIVIP to the IP address for the Host RJ-11 IP Gateway (in the example,
192.168.1.4).
c. Verify the *HOSTPEERIP is the local IP of the modem. Set this to 192.168.1.3 if you are keep-
ing the default IP address for the Host RJ-11 IP Gateway.
d. Set the *HOSTNETMASK to the Subnet Mask (generally 255.255.255.0).
FIGURE 3. Wireless Ace: PPP/Ethernet
FIGURE 4. Wireless Ace: Write
A. Select Status from the menu on the left side of Wireless Ace (under “Groups”).
If the modem and the Host RJ-11 IP Gateway are going to be on a LAN with other
computers and devices you may want to use Private Mode. On a LAN, a DHCP
server other than the modem may give the Host RJ-11 IP Gateway an IP address to
which the modem would not know to send its messages.
4.
When you have finished configuring the Ethernet settings, click the Write button on the tool bar
of Wireless Ace and wait for the message “Write Successful” to appear in the status bar.
5.
Note the IP address given to the modem by your cellular provider.
1 - Use Private IP
192.168.1.4
192.168.1.3
255.255.255.0