Raven-E iDEN Quick Start Version 2.40 - September 2006 Copyright © 1993-2006 AirLink Communications, Inc. All rights reserved.
Raven-E iDEN for TELUS - Quick Start, version 2.40 The SIM (Subscriber Identity Module) card in the Raven-E is a smartcard securely storing the key identifying a mobile subscriber. Generally, you will only need to install the SIM once in the life of the modem and it may be pre-installed by AirLink. For additional modem configuration options, please refer to the Raven-E iDEN Users Guide for TELUS. Note: If the SIM card was pre-installed by AirLink, there is nothing more you need to do.
Raven-E iDEN for TELUS - Quick Start, version 2.40 a. Using the tip of a PDA stylus, an unbent paperclip, or other slim blunt item press the yellow button of the SIM tray. On the Raven-E, the button is between two boards. FIGURE 2. Tray button: Raven-E b. Slide the tray out of the slot. FIGURE 3. 3. Empty SIM Tray Inserting the SIM a. Place the SIM into the tray and gently press to click it into place. FIGURE 4. SIM Tray with a SIM The SIM may be a different color than this example. b.
Raven-E iDEN for TELUS - Quick Start, version 2.40 4. Finishing the SIM installation a. Slide the Raven-E back into the case. b. Secure the back of the Raven-E with the screws. Modem Master Reset The final step is issuing a master reset for the Raven-E. You will need to connect to theRaven-E using a terminal application such as HyperTerminal and connect directly to theRaven-E from your computer. 1. Connect your modem to your computer using an Ethernet cable. 2. Connect theRaven-E to power. 3.
Raven-E iDEN for TELUS - Quick Start, version 2.40 tional verification. You should ensure that there is adequate airflow around the modem but that it is kept free from direct exposure to the elements (sun, rain, etc.) An optional accessory for your modem is a mounting kit. The bracket is designed to snugly cradle the modem and hold it in place where you need it. Connecting the Antenna Antennas selected should not exceed a maximum gain of 5 dBi under standard installation configuration.
Raven-E iDEN for TELUS - Quick Start, version 2.40 Your Raven-E’s Ethernet port can be connected directly to a computer or other Ethernet device using a cross-over cable. Most newer computers have an auto-sensing Ethernet port allowing you to use a straight through cable. If you are connecting the modem to a hub or switch you should use a straight through cable or use the uplink port on the hub or switch with a cross-over cable.
Raven-E iDEN for TELUS - Quick Start, version 2.40 • Utility Guides - These guides focus on the features of one of the AirLink modem utilities: Wireless Ace, AceView, AceNet, Modem Doctor, etc. • Application Notes and How-To Guides - These guides detail configuring the modem to work with a specific feature set or how the modem can be set up to work with a specific 3rd party (non-AirLink) device. • Data Sheets and White Papers - These are technology based information documents.