Network Hardware User Manual

Ver. 1.0
Section 1
Hard Drive Installation
Step 2 Pull out the front panel.
Step 3 Put the 3.5-inch IDE or SATA hard disk into the slot, and connect the
proper data cable for your hard drive. (The red cable is used for SATA and the gray
one is for IDE).
Package Contents:
Office NAS
Vertical Stand
Power adapter
Ethernet Cable
Utility CD
Quick Installation Guide
Screws (4)
Rubber feet (4)
Quick Installation Guide
Office NAS
3.5” IDE/SATA Network Attached Storage
WARNING:
Step 1 Unfasten the two screws at the rear side of the device, and pull out the
back cover.
Step 3a IDE
This Network Attached Storage device is not hot-swappable. Please make sure that
it is turned off and not connected to the power outlet when performing the following
assembly procedure.
Model # ANAS350

Summary of content (4 pages)