Network Router User Manual

If you want to delete a specific item, please check the “Select” box of a MAC address and IP

address mapping, then click “Delete” button. If you want to delete all mappings, click “Delete

All”.

After you finish with all settings, please click “Apply” button.

If you want to reset all settings in this page, please click “Cancel” button.

After you clicked Apply, the following message will be displayed on your web browser:

You can click “Continue” to back to previous setup page to continue on other setup procedures,

or click “Apply” to reboot the router so the settings will take effect (Please wait for about 30

seconds while router is rebooting).

3.1.3 NAT / Static Routing

Network address translations (NAT) shares a single public IP address to multiple computers. All

computers must be assigned a valid public IP address to be able to get connected to Internet,

but Internet service providers provide very few public IP addresses to each user based on

service plans, usually 1 for each household. Therefore, it’s necessary to use NAT technology to

share a single Internet IP address to multiple computers on a same local network, so everyone

can get connected to Internet.

The NAT function is enabled by default; to disable it, you need to enable Static Routing by

checking the “Enable Static Routing” box. Do not disable NAT unless you have professional

knowledge on routing.

Please follow the following instructions to set Static Routing parameters: