Network Router User Manual

RTS Threshold When the packet size is smaller than the RTS threshold, the

wireless router will not use the RTS/CTS mechanism to send this

packet.

Beacon Interval The interval of time that this wireless router broadcast a beacon.

Beacon is used to synchronize the wireless network.

DTIM Period Set the DTIM period of wireless radio. Do not modify default

value if you don’t know what it is, default value is 3.

Data Rate Set the wireless data transfer rate to a certain value. Since most

of wireless devices will negotiate with each other and pick a

proper data transfer rate automatically, it’s not necessary to

change this value unless you know what will happen after

modification.

N Data Rate Same as above, but only for 802.11n clients.

Channel Width Set channel width of wireless radio. Do not modify default value

if you don’t know what it is, default setting is ‘Auto 20/40 MHz’.

Preamble Type

The “Long Preamble” can provide better wireless LAN

compatibility while the “Short Preamble” can provide better

wireless LAN performance.

Broadcast ESSID Decide if the wireless router will broadcast its own ESSID or not.

You can hide the ESSID of your wireless router by selecting

“Disable”

CTS Protect

It is recommended to enable the protection mechanism. This

mechanism can decrease the rate of data collision between

802.11b and 802.11g/802.11n wireless stations. When the

protection mode is enabled, the throughput of the AP will be a

little lower due to many of frame traffic should be transmitted.

Tx Power You can set the output power of wireless radio. Unless you are

using this wireless router in a really big space, you may not have

to set output power to 100%. This will enhance security

(malicious / unknown users in distance will not be able to reach

your wireless router).

WMM The short of Wi-Fi MultiMedia, it will enhance the data transfer

performance of multimedia contents when they are being

transferred over wireless network. The default value is “Disable”.

After you finish with all settings, please click “Apply” button.

If you want to reset all settings in this page, please click “Cancel” button.

After you clicked Apply, the following message will be displayed on your web browser: